Peachtree Corners GA Electrical Service And Repairs

Replacing the Existing Small Sub panel in the Basement 12 to a 24 circuit panel Demo (1) Basement Dryer Circuit in the New Sub Panel Installing (11) Saftey Breakers for Basement Circuit Reinstalling (1) Basement Surge Protection Devices Installing (1) 60a 240v Circuit for the New Tesla Wall Unit in the Bigger Garage Running 3/4 PVC in the Bigger Garage Installing (1) Customer Supplied Tesla Wall Unit at the preferred location in the garage Note-Disconnect The. Basement Dryer Circuit from the Dryer Breaker in the Sub Panel-per Mr Lim

Customer called about a leak in home. TE arrived and conducted leak detection via cutting drywall. Source of leak is a pinhole on a half inch copper line supplying toilet and main bathroom.Repaired section of copper and replaced angle stop. Tested for leaks.

Sewer ejector pump failed, causing basement plumbing to be inoperable Found Home Depot low budget pump is the cause of failure Customer elected to upgrade to a one horsepower liberty grinder pump I also installed a high water alarm, so everyone will know if there is a problem with the pump Tested the pump and tested the high water alarm both are working excellent

Customer called us out for a clogged toilet in the upstairs master bathroom. On arrival I tested the bathroom grouping and the toilet started to gurgle. I gave the customer an estimate and they agreed. I removed the toilet and ran my cable machine down the drain line successfully clearing the blockage. I then tested using the rest of the bathroom grouping. I cleaned up and reset the toilet.

Today we completed the following work: -In the dining room area we removed the existing fixture to install a new customer supplied one. A pancake box was already in place and was properly bonded so no further work was required. After installing the fixture we ensured the height and position was to the customers satisfaction. The switch that controls the fixture is located on the wall by the kitchen. In the kitchen we removed the (3) remaining 6” baffle trims and bulbs and installed (3) new customer supplied smart trims. After installation we tested three lights to ensure they are working. -Customer Concerns- The customer had a contractor over to do work on the kitchen island and dishwasher and wanted to have it checked out and this is what was found: -Kitchen Island- On the kitchen island is a white duplex outlet and a plate I used a plug tester to test the device for proper wiring and to ensure it is being GFCI protected per 210.8 of the NEC. The plug tester had indicated that th

Replaced both original pop up assembly’s in master bath with new cs push to stop pop ups. Also removed old caulking from master shower base to reseal with white caulking. Secondary bathroom upstairs toilet pulled and reset to properly shim and eliminate rocking. set new bolts, wax and caulking. Lastly set new gasket and sealed for sewage ejector pump basin.

Front porch GFCI outlet is damaged Recommend whole house surge protector Replace main floor hall bathroom vanity light Replace closet light in daughters bedroom with wafer light Elliptical equipment is reading error code (base communication error) Other equipment damage from lighting WiFi extender and modems

Replaced toilet flapper for gerber toilet on main level half bathroom. Tested and ensured new flapper is holding water level at appropriate level. Flushed toilet multiple times to ensure flapper is sealing properly.

Came out to customer’s house due to an airflow issue. Noticed that the vent the customer was having issues with was not connected to the upstairs system, but was connected to the first level system. I also noticed that the float switch in the pan is defective, no water safety on drain, run capacitor for blower motor is out of manufacturer specs, condensate drain doesn’t have enough pitch, zoning is very old and can possibly fail at any point, flue pipe was disconnected (I turned off the shut off valve to prevent the heat from coming on), gas sediment trap isn’t up to code, condenser coil is dirty, contactor is burnt, and system is low on refrigerant. Based on our findings today, it might be time to think about getting a brand new system. Thank you for choosing TE CERTIFIED.

Arrived on site for no cool call. Checked in with customer and he showed me attic access where unit is located. Per customer “ so yesterday I had a maintenance done on the unit with another company and he told me I needed the float switch replaced. He did the work then after he left the unit stopped working. I noticed the pump for the water had filled so I emptied it and it started working again. After about an hour it had stopped again” Went into attic space where air handler is located and found condensation pump to be full and the emergency drain to be full as well. The wet switch for emergency drain has tripped and is preventing the unit from working. Unit does need a new condensate pump. Customer signed for a new condensate pump, took off older pump and replaced with new one. Made sure wiring was correct and after the 5 min compressor safety was done, unit started up in cooling. System is working properly at this time.

SERVICE CALL: upon arrival homeowner stated the second floor hvac system is not working properly on cooling mode. After complete troubleshooting I found the Lennox system 2 ton capacity 13 years old is in poor maintenance conditions no Safety flood protection plus check indoor blower motor it’s dirty check run capacitor is out of spec from manufacture. Test outdoor condenser unit is completely out of refrigerant r 410a which is already phased by EPA. No refrigerant that’s indication of mayor leak Performed courtesy leak search and I found the indoor evaporator coil is rusted out and is leaking refrigerant system is 13 years old the life expectancy from manufacture are 10 to 12 years I called distribution center and they don’t have the indoor coil available only the compressor the waiting time will be approximately 10 business days. Due to aged and conditions vs costs of repairs recommend to upgrade complete system. Homeowner is aware of the conditions of the equipment. Customer wa

Figure out what why fluorescent fixture is not working Install new led tube lights , ballast bypass, tombstone replacement and rewire fixture.

Customer says compressor is making a noise. Inspected start up amperage and operation amperage. Inspected starting components. Inspected operating pressures. Tech did not hear noise but compressor may be failing internally. Found system low on charge. Recommended leak search. Customer opted out on leak search. Customer moved forward with topping off charge. Equipment is zoned but zoning does not have static bypass. Recommended installing bypass.

On this visit we installed a new 60A circuit from the meter breaker space outside to the garage. We ran conduit and installed the Tesla Wall Connector and configured it to the app with the customer. We check for proper power and tested. We then signed for satisfaction and received payment.

Leak search

Correct the attic furnace wiring by cleaning up the existing wiring, add necessary circuits for the separated wires, and install lighting and service outlet in attic.

For this job, we worked on installing 2 customer provided exhaust fans.

Customer called about a leaking water closet. TE arrived and inspected toilet. Advised to repair or replace Flushometer. Water pressure is safe at 55psi. Advised to prepare for a replacement of water heater given age is 12 years old. Customer stated they will proceed with a repair for now and will defer on other options for now.

23 year old electric water heater with signs of failure. Removed and replaced. Made all plumbing code adjustments. Turned on the water heater and tested.

Toilet rebuild on master bathroom toilet and powder room bathroom. Major rebuild on both toilets, new fill valve, flapper, and seals.

For this job, I came to look at a system that was leaking. Once I arrived, I noticed that the drain pan was full of water. I proceeded to test the system and its functions and noticed that the system was low on refrigerant. I noticed that the Schrader valve had a leak. While inspecting the system, I also noticed that the zone system was outdated, and I created an estimate to replace with the brand new zoning system, as well as replacing the capacitor that’s bad and upgrading the flood protection. I also created an estimate for the customer to join our home care. Today she went with the Band-Aid option and I was able to complete the repair.

Arrived spoke with customer he stated system has not been cooling for a couple days. Checked indoor unit. Found dirty evaporator coil and dirty blower wheel. Bad run capacitor. No in-line safety no wet switch. Checked outdoor unit. System low on refrigerant. Found failing dual capacitor. Capacitor already has been changed once indicating failing outdoor fan motor. And the compromised compressor due to system running on low refrigerant. Performed quick electronic leak search. Found refrigerant leak at evaporator coil and TXV. Recommend system replacement. Based on our findings today, it might be time to think about getting a brand new system.

Attempt to clear kitchen sink blockage Customer called us out for a kitchen sink that was not draining and coming back up on the other side. Upon arrival customer stated this started happening in the morning. They have experienced this issue a few years ago and had the line snaked. We went to the basement to ensure there were no signs of water damage in the ceiling under the kitchen line. There was no signs of damage and then we went to the main floor to perform some tests. We ran water on the right side of the sink and we noticed the water started to puddle and we saw it come back up on the left side with the disposal. The customer agreed to attempt to restore proper flow by using our cable machine. We went to cable the kitchen drain line and after multiple attempts we were successful in restoring proper flow. We did multiple tests to ensure there was not any leaks or backups around our work. Customer was satisfied and thank you for choosing for Te Certified!