Your locally trusted electricians, plumbers and technicians in Brookhaven, GA

The homeowner is still experiencing luke warm water through the house and periods when the water is at the correct temperature. On this trip isolation valves were added at the Thermostatic Mixing Valve to test the system without it being a factor, and all of the Moen Posi-Temp cartridges were replaced. The water heater, PRV, check valves, recirculation pump, kitchen faucet, and thermostatic Mixing Valve have been replaced approximately 9 months ago. Tested with the the mixing valve isolated and in service and the temperature at all of the fixtures were tested multiple times and at different length intervals. The temperature is reading consistent every time tested. Homeowner has the temperature set to 135 degrees.

Replaced existing Wilkins PRV with new. Installed customer supplied Toto toilet, straight stop, and supply line. Turned water on and tested all work for proper operations.

Conducted troubleshoot of ceiling fan.

For this job we checked all cat 6 lines that they we’re working properly gave a estimate on relocating a cat 6 from master bedroom to office.

Pulled upstairs master toilet to clear blockage. Ran cable to clear line blockage unknown . Tested thoroughly. Reset toilet.

Customer called us out for two clogged sinks. We used the cable machine for the one in the basement and just did a regular cleaning for the one in the master bathroom

-Single stage air conditioner (outdoor) / Single stage, constant torque furnace (indoor). -10 year parts warranty (20 years for heat exchangers on 80% furnaces) -10 years labor coverage when a Home Care maintenance plan is held with TE Certified. Lifetime Craftsmanship. -Removal and disposal of existing system. -Permit fees are included, system will be installed to meet or exceed county’s codes. -Cost includes all required material, tax, & labor. No further charges will apply. -New drain pan, safety float switch, water safety and condensate pump (if applicable). -New outdoor electrical disconnect and new pad for outdoor unit. -New flexible gas line and hard pipe gas connection to furnace. -Flush, Clean and Test Existing Line Set and Pull Vacuum to 500 Microns. -Will recover existing refrigerant per EPA guidelines. -Will complete leak check and system & system start up. . -Bring existing flue pipe up to current code as needed with double wall flue pipe.

Disposal was stuck, blades are intact. Reset disposal. Left estimates for future work.

Cut sheetrock below (kitchen) wall between master shower and toilet. Found leak coming from above subfloor. Cut behind shower in toilet closet. Found leak coming from red pex-a coupling. Removed and replaced leaking section. Tested to find no leaks. Cleaned area.

Replaced filters. Cleaned drains and panels. Checked all operations. Completed quoted work.

Came out today to start work on house projects the homeowner is having done. I replaced the table chandalier. Replaced a kitchen flush mount with a wafer light. I put the wafer light in a dimmer and the kitchen cans on a dimmer. I replaced a flush ,punt in the entry way and put that on a dimmer. I replaced 2 flush mounts with wafers in the upstairs hall. Tested everything and it works properly. Customer is happy.

Came here today for a unit not cooling properly…checked system verified charge …fliers is ok …2018 Lennox ..gas furnace 3 zone system …no flood protection on attic system drainage …checked drainage ….refrigerant charge looks fine .no indication of freezing of the system …while ..here or leakage ..static pressure was 0.7..tested both in cooling …system is single stage builders grade on 3 zone application….did explain how the system works in to cooling on zoning on a attic system …did adjust set point at thermostat so basement and main level as suggestion going forward …unit is operating ..

Lighting upgrades

Ran conduit and a new circuit in the garage from the main panel to the new charger location and blanked off the existing outlet in the owner suite bathroom and moved it into the cabinet space

Troubleshoot tripping breaker for garbage disposal and install a whole house house surge protector

Microwave breaker replace

Performed routine flush on two 50 gallon electric water heaters While performing flush, noticed that water pressure in plumbing system was very high. Pressure was above 100 psi. Recommended range is between 50 to 70 psi. This was due to poor quality pressure regulator installed by builder. These poor quality regulators tend to last between 2 to 5 years on average. This one was 4 years old. Highly recommend replacing it with a new high quality whole hoke pressure regulator to address extremely high pressure. Noticed that there also was no thermal expansion device present either to address pressure increases in plumbing system due to thermal expansion when water heaters heat water up. Recommend installing a thermal explain tank to address this issue Also, found no check valve present on cold inlet to water heaters to prevent cross connection of hot and cold water lines due to the recirculation line. It is required to have a check valve installed in cold inlet to water heaters as well

Install customer supplied chargepoint in garage and surge protection. Also replaced to can light trims in basement theater room. Also replaced failing GFCI outlet below the panel and 2 outlets in basement on same circuit. Recrimped and pigtailed all appropriate wiring in only boxes effected.

Installed a hardwired EV charger in the garage on a new dedicated circuit and Installed a whole surge protector

Troubleshoot lights not working.

Install 3.5 ton TE PRO 16.6 seer2 air conditioner, all aluminum cased evaporator coil, 80% efficiency 80,000 BTU gas furnace with ewc zone system.

Technician completed home care spring maintenance. Tested heat and cooling at thermostats. Replaced 20x25x4 provided by customer. Recommended UV light coil protection to help prevent refrigerant leaks. System is cooling at this time. Thanks for choosing TE Certified if you liked your technician service today don’t hesitate to leave a 5 star review!

Ac freezing up 2013 Lennox 3.5 ton with matching 90+ furnace. Found contactor welded shut and condenser coil impacted with dirt. System is frozen solid from evaporator coil to ac unit and line set has been leaking onto plywood will attach pictures to invoice. Checked refrigerant levels found no refrigerant in circuit. Performed complimentary leak search found evaporator coil leaking in attic. System is zoned with single stage equipment when it should be modulating and system is basic builder grade.Due to equipment being over ten years old and manufacture warranty being expired equipment needs to be updated.

Replaced hallway bathroom shower cartridge to stop leaking.

Completed a thorough electrical inspection for a kind and humble man in Chamblee.