College Park, GA Electrician Plumber HVAC Service

Today as I arrived I installed a new AC disconnect on the outdoor unit along with a whip going from the disconnect to the existing unit. I also installed a disconnect switch in the crawlspace for the 120 V furnace blower. Once all connections were made in power was restored both units worked properly. It was very nice meeting you today! If you have any other questions about the whole home, Generac generator or need anything else at all please feel free to give me a call anytime. Thank you, Brandon

Customer scheduled quoted work to be done. Scope of work is to install customer supplied kitchen faucet and lavatory faucet. Lavatory faucet shut offs are no holding water. Advised to replace angle stops. Customer deferred from replacements. Shut water off to home and drained system. Installed customer supplied faucets. Turned water back on and tested for leaks.

No cooling call, upon arrival system was running however system does not have any refrigerant, informed customer that R-22 refrigerant is obsolete as of January 2020, recommended having install supervisor come out and quote the replacement of the system, customer declined install supervisor left option for system update if customer changes their mind they will let us know

Arrived at the customer’s home to perform a one-system Home Care inspection. Upon inspection and testing, the system was found to be operating and cooling properly from a refrigeration and cooling standpoint. However, several maintenance, safety, and equipment concerns were identified that should be addressed. The outdoor condenser currently does not have a disconnect installed. Additionally, there is no light switch or disconnect provided for the furnace located in the crawlspace. Proper means of disconnect are important for technician safety and may be required to bring the installation into compliance with applicable electrical and mechanical codes. These items should be evaluated and corrected as necessary. The outdoor contactor is also showing approximately 10 ohms of resistance, which is higher than expected for a properly functioning contactor. Elevated resistance across the contactor can result in voltage drop and increased heat generation, potentially placing additional stress

Perform spring inspection on Goodman unit, check tstst, already in ac mode, dropped temp to 62, inspected air handler /fan coil, replaced filter (14x18x1), checked blower wheel, checked evap coil, inspected drain line, no way to pour water in drain, recommend wet switch for flood protection, inspected outdoor unit, noticed impacted due to dryer vent, recommend chemical cleaning, checked capacitor, contactor, amp draws, checked pressures and temp split, went over all repair options, customer stated his warranty company was just here, explained they did not clean coil, customer approved option a, chemical cleaned heat pump, rechecked pressures, unit working at time with no issues

Lightning Damage Inspection

No Cool Diagnostic Summary & Recommendations Came out for a no-cool complaint following a lightning strike and major power surge at the home. The customer stated the lightning also struck a tree beside the house and disrupted a portion of the incoming electrical power. After fully diagnosing the affected 2020 Goodman 2-ton R-410A heat-pump system, I found extensive damage throughout both the indoor and outdoor equipment. The indoor blower motor, outdoor condenser fan motor, contactor, indoor control board, outdoor control board, indoor transformer, and TXV have all failed. With this many major components damaged at the same time, this is no longer a practical individual-component repair. There is also no way to guarantee the long-term reliability of the remaining electrical and mechanical components after a surge of this magnitude. At this point, I recommend complete system replacement rather than investing in multiple major repairs. I also recommend enrolling the customer in our H

Arrived on site, homeowner showed me to basement where shower is constantly dripping. Homeowner removed trim for shower prior to my arrival. Turned off water to home and removed existing cartridge and installed new Moen 1222. No leaks at this time.

Complete Water Service Replacement Arrived on site and met with the homeowner. The homeowner approved the replacement of the entire water service from the water meter to the point where the service penetrates the home. Prior to beginning work, the homeowner was informed that a new penetration through the home would be required to properly install the replacement water service. The existing penetration was not utilized, and a new penetration was created to accommodate the new service piping and provide a proper installation. The existing meter connection was addressed by installing a new meter nipple, along with a new dual-check valve and new isolation valve inside the newly installed meter box. These components provide proper connection, backflow protection, and the ability to isolate the water service when necessary. From the meter, a new 1-inch Endo polyethylene water service line was installed and routed to the home. A new penetration was made through the structure, and soft Typ

Arrived on site and met with the homeowner, who directed me to the front yard where there were visible signs of water loss and moisture protruding from the ground. Based on the location and visible conditions, the water loss appears to be associated with the underground water service line supplying the home. The homeowner stated that the home was originally built in the 1960s. Due to the age of the home and the apparent underground water loss, I informed the homeowner that our recommendation is to replace the existing water service line rather than attempt a repair. Given the age of the property, there is a possibility that the existing water service is original to the home and has reached the end of its service life. I hand-dug at the water meter to expose and identify the existing water service piping. Upon inspection, the existing water service was found to be galvanized steel piping. The condition and age of galvanized water service piping can make repairs difficult and unreliabl