Sugar Hill, GA | Electricians, Plumbers, & HVAC Techs

Replaced water service line from meter to home. Installed new shut off valve in box by meter.

Dryer breaker tripping -install correct 3 prong dryer outlet -install correct dryer cord for 3 prong outlet

Installed new main water service line from meter to back left of house. Also new 8” valve box, courtesy valve at meter and inside meter box at house connection new Wilkins Prv and ball valve. Also, homeowner decided to add a hose Bibb cut wall removed old hose Bibb and tied into main line. Pressurized house purged out all fixtures. Tested house. Static Pressure on home at 60 psi. No leaks

Homeowner had called in says the upstairs thermostat is showing an error code. Observed a Y one error code only on the upstairs thermostat. Main floor thermostat was functional and turned on the cooling with no issue. Observed the C wire, not illuminated under equipment. The common wire for the thermostat had come loose. I did not have this error code when I worked on the equipment.

Replaced main shutoff gate valve with new ball valve. Isolated after new valve installed to see if main water line has a break in it. Turned on meter left off ball valve meter still spinning. Informed homeowner the ways he could proceed. Replacement of water line recommend. Also, may do spot repair after a leak search has been completed and marked area were they think leak is located. Removed old gate valve, installed new ball valve. Tested fixture. No leaks

For this job, we worked on redoing a junction box that was done poorly from the beginning. neutral was broken off, and they were using the switch to turn off the neutral instead of the switch leg so we replaced the outlet, the switch, redid the junction box and bonded the box as it was not before. will leave an estimate to replace the breaker and the light fixture as well.

Install outlet in desired location

For this job, I came to look at a call in which the system was not heating. Once I arrived, i proceeded to put the thermostat in heat and inspect the indoor unit. I noticed that, although the thermostat was calling for heat, it was not relaying a signal to the board to turn on the heater. After Troubleshooting, I was able to determine that the issue was with the program settings for the thermostat. The thermostat was set as a heat pump, although it is a gas furnace. I proceeded to change the settings on the thermostat as well as properly test the unit in heat and cool to ensure that everything was working. While here I showed the customers my findings, as well as provided estimates. Thank you for choosing TE certified.

Found stream of water coming out of ground on right side of home, dug down area to locate busted 1 inch to three-quarter fitting on main service waterline. Cut damaged fitting out and reconnected with proper fittings, turned the water onto to test and a proper function and backfilled hole.

Arrived at the home due to some outlets not working, during the troubleshooting process we noticed locations lacking GFCI protection, no surge protection in the home and neutrals and grounds were landed together and double tapped. Installed GFCI protection where needed throught the home, including, outdoors, kitchen, garage and bathrooms. Also installed a whole home surge protector and separated neutrals and ground in the panel.

Came out to pinhole leak and copper line in garage. Also replaced PRV set new PRV to 65 psi.

Replace gas supply line that is leaking and install a new gas line and gas connections.

Came out to leaking water service line main waterline was gray poly explained to customer that I would recommend replacing the entire waterline

Troubleshoot issues

Bond gas lines and replace incorrect sized breaker for AC

Replace 3/4” pressure regulator valve and set water pressure to 65psi. Remove old 2 gallon thermal expansion tank on water heater and install a new one and strap properly according to plumbing code. Also move water heater shutoff valve to in front of expansion tank.

Diagnostic for 1 system for the main level and basement. R-22 2003 system with a restricted evaporator coil, rust due to age and growth inside the coil case. Duct board plenums, rusted flue vent and burner compartment. No possible repair options due to R-22 being outlawed. Based on our findings today, it might be time to think about getting a brand new system.

Install customer supplied Tesla charger at the panel. We installed new 6-6-8 copper wire, a 60 amp breaker and programmed the Tesla charger. The box and customer setup paper is next to the charger

Troubleshooting/ new breaker.

Perform a hydro jetting in toilet drain to clear bloackge that a cable machine could not clear. Use mini camera to confirm blockage is cleared. Reset toilet once completed. Cleared the debris and found a piece of tile was stuck in the line. Sewer supervisor will be out to inspect. Pressure was also 90psi.

I performed a troubleshoot on the main electrical breaker after it tripped last night. The homeowners went to be with the car charging and woke up with everything in the house off. He tried to reset the main breaker outside but was unable to do so. The meter is loose and falling off of the wall, however the connections and voltages were still good. I turned the main back on and tested the breakers one by one. I turned on everything in the house and started charging the Tesla charger and could not replicate it tripping anything. I suspect they may have gotten hit with a surge overnight and that’s the cause of the tripped main.nEverything was working properly again. I left estimates to add surge protection, and to Resecure the meter. I also informed the homeowner that they have a 150 amp service and if they continue having issues we may have to look at doing a service s upgrade.

-troubleshoot breaker tripping -replace 3 bad arc fault breakers with brand new ones

Install Fridge outlet with new 20A circuit Install 20A circuit below panel

For this job, we worked on doing a ballast bypass on all office areas and bathroom light fixtures. We also replaced and repaired three separate 3-way light switch systems. We also removed an extension cord that was coming out of the wall and was tied into the light switch.

Completed repairs for small office