Waleska GA Electrical Service And Repairs

New home care plan added, and maintenance visit performed. Discuss findings and options. System heating and cooling upon departure. Thank you for choosing TE certified!

Technician pulled and reset toilet in master bathroom due to leak dripping through the ceiling. Upon removal of the toilet the flange was found to be below the floor grade. Technician then performed repair to rectify the root cause. Toilet was then reinstalled, sealed and tested thoroughly. No leaks are present at this time. Technician also found that the thermal expansion tank is not strapped accordingly and highly recommends correcting the issue as soon as possible. Estimate will be sent separately.

We were called out due to a master bathroom shower issue and a leak in the crawlspace. The shower head was leaking from the top of the shower head when the water was turned on to the shower. We installed a customer supplied shower head in the master shower as well as the basement shower. There was a leak just past the shutoff valve for the hose bib on the left side of the home. We installed a new hose bib and hose bib shutoff valve along with roughly 10’ of new piping. While onsite we replaced a customer supplied filter cartridge in the crawlspace. Thank you !

No cool on a Goodman heat pump from 2021 and a Rheem air handler from 2020. Customer said system froze over about two days ago, he did replace the filter once the system defrosted. But system still wasn’t cooling properly. Once I put my gauges to check the refrigerant pressure it seemed to be like there was a blockage in the refrigerant. The liquid side was over 500 psi. I went ahead and tested the TXV with a cold glass of water and my holding tight in my hand. The TXV was working properly. Then I checked the filter dryer with two clamps on each side. The filter dryer was also good. I decided to recover about a pound or so of refrigerant to see if the pressure stabilizes it. Once I recovered the refrigerant the system did stabilize and started to cool properly. The drain line was also clogged and there was no safety switch. Customer decided to go ahead and have drain line unclogged have a T vent installed and a safety switch. System is running properly upon departure. Thank you for usi

For this call, homeowners were having an issue with the master Roman tub where they stated water was shooting out of the cartridge slot and they had to turn the water off to the home to stop it. Once we arrived, we tested the street pressure and saw it was 150 PSI which in addition to an old PRV, it likely went bad. With high street pressure, a regular PRV would not be able to withstand the street pressure so to alleviate that we had to throw in a higher pressure rated PRV previous to a regular PRV to get the home with in an adequate pressure range. Once we completed that, we also changed out a bad expansion tank and put in new cartridges to that romantub. At this time everything is working as it should at this time. We also left estimates to put in new yard hydrants outside the home. Thank you for trusting TE Certified with all your plumbing needs.

Service visit on Generac 32kw standby generator

Performed trim out. Installed ceiling fan and sconces. Replaced breaker

For this call, homeowner called because he had an electric water heater stop working recently. Upon inspection, we saw that there was a leak coming from the hot side nipple and had a rust trail into the electrical connection port where it had water in as well. We let homeowner know it would require replacement and gave estimates on different warranty durations from, 6-10 year warranties. Homeowner decided on the 6 year heater. The wiring from the panel to the water heater was likely original to the home as it’s run with aluminum. We had an electrician come out to put in a disconnect as it is in a laundry closet and will transition the aluminum wiring to copper to prevent electrolysis from occurring. We also had to run the T and P line outside the crawlspace as before it was dropping straight into the crawlspace instead of out the side of the home. After we removed the old heater and installed the new one, we checked all of our work of proper functionality and no leakages and all is wor

Whole Home Surge Protection

Flooring company removed the toilet in the upstairs hall bathroom to install new flooring. The toilet was installed incorrectly which caused a leak in the ceiling of the kitchen. I reset the toilet with a new wax ring and bolts. I sealed around the base with clear silicone. The toilet has been tested thoroughly. Thank you for choosing TE Certified!

Today we were called out here because Lisa discovered a leak coming from one of the shark bite fittings that was put in when work was previously done to the home from a contractor. The fitting that I noticed was a gray polybutylene to pex adapter coupling. The pecks pipe was connected to the gray polybutylene side of the coupling was the reason why it was leaking to begin with because it’s not the same diameter as for the pecan piping. I recommended to get rid of the shark bite fittings because they are temporarily and not permanent fittings. Lisa agreed to replace them and also swap out the PRV that they are having pressure issues. I replace shark bite fittings with proper pressed fittings that bond better to the pipe and swap out PRV with new main shutoff. Turn the water back on to test the fittings that I have put in for any leaks and found no issues. We are also here for today and there are no other plumbing concerns.

Arrived to finish up rough

Arrived on site and customer stated that the one of the water heaters T&P was popping while inspector was walking through the house, and requested homeowner get T&P replaced. Water heaters were installed in 2023. Everything around the heater was functioning properly. Pressure was 60 , expansion tanks was filled with air, and gas control valves were in normal sequences.

Installed can lights on porch with fan. New sconces roughed and roughed in outdoor outlet

Service visit on Generac 22kw standby generator

Installed customer supplied motion sensor light switch in the laundry room Rerouted low voltage wires for stereo system on the mantle in the living room through the fireplace Pulled power off TV receptacle for a receptacle and switch on the bar top. Pulled a switch leg for a 4 inch waffer over bar top. Replaced a Dual Function Siemens breaker for a AFCI breaker due to the treadmill causing the breaker to trip. We informed the homeowner that the treadmill should be on a dedicated 15/20a circuit.

For this job the customer stated they had a disposal that was making a loud humming noise and the impellers were not working. Further inspection showed a sink that was slow to drain due to the disposal being clogged and non operable. I recommended replacing the disposal with a new more powerful one. The customer agreed and the old disposal was removed and replaced with a new 1/2 hp badger disposal. After disposal was installed I tested it multiple times including filling and draining the sink as well as running the dishwasher. No leaks were observed and the disposal was in proper working order.

Arrived on site and completed propane connection for the customer generator . We originally tried to fire up the unit but customer stated the electrical department is coming out to finish the electrical and test fire the unit

System inspection completed. Filters replaced. Drain line cleaned. No immediate issues noticed. Cycled power for 10 minutes to read the communication glitch. Discuss findings and enhancement options. System cooling properly at this time. Thank you for choosing TE certified!

Arrived on site and customer stated a leak as coming from the meter . Customer agreed to have me dig up and locate the leak to determine the issue . Once front of the meter box was cleared , and found a check valve leaking. I had to cut out the check valve all the way back to the meter to make the repair.I replace the meter nipple , check valve and replaced the ball valve that was on the line . Once repair was made I turned the water back on at the meter and checked my repair are to ensure no issues . Water is back on to the house and pressure is 60. Additionally I left quotes to repair the hole water line .

The living room outlets left and right of the fireplace were not working. The issue was due to a toggle switch located on the foyer area being turned off. As a courtesy we bypassed the switch for the come owner allowing for constant power to the outlets. We also found that plug mold and wiring was installed improperly to the right of the fireplace we left an estimate for the correction.

Wire in and install a new location outlet in the closet near the living room Interlock kit that we provided was the wrong interlock kit will have to return to install interlock. Oil was provided by customer and we poured oil in generator. Made sure generator was hooked to generator outlet and hooked up to generator.

Arrived on site and customer had a toilet in the downstairs bathroom that needed to be reset and the flange needed to replaced. I cut out the Brocken flanged cleared debri , set a new wax ring and bolts and reset the customers toilet. Toilet is back up and fully functioning.

Complete the following work: Remove the (2) existing flood lights located front left of home at soffit and back right of home on soffit and install a new customer supplied floodlight with security camera. Wire in (3) new location flood lights with attic access for the back left of the home in soffit, front right and back right of home. This will include a power supply, boxes wiring, and positioning the cameras per customers request Install (2) customer supplied motion sensor switches in the pantry and laundry room

Replaced kitchen recessed lights with new integrated recessed trims. We replaced 6 bulbs in the master bathroom with new customer supplied bulbs. We also added a new outlet in the master bed closet. The homeowners are happy with the 3000k color on the kitchen lights. I also discussed installing a whole home surge protector at the main panel and replacing their expired smoke detectors. Everything is working upon completion. We need to main over the invoice, estimate, and warranty info