Morrow, GA

Installed 3 new customer supplied toilets along with new angle stops in all bathrooms. Replaced flange inside hallway bathroom due to deterioration. Flushed all toilets and tested for proper operations with homeowner.

Customer had a damage 2/0 SEU Cable/Meter Socket- Installed (1) 150a Meter Mast Pipe Meter Main Breaker Enclosure 150a Grounding System Saftey Breaker (14) Whole Home Surge Protection Device New 2/0 SER Cable from the meter main disconnect to the 150a panel in the laundry room I had to add a ground bar and separate the neutral wires from the ground wire Permit Note to customer-the cold water pipe coming into the crawlspace is damaged and leaking-customer is aware the water problem I did not touch the pipe to installed the line for the PRV-Once the pipe is replaced with a another copper pipe-then I add my ground wire Courtesy for installing (1) dryer circuit with a GFCI breaker-First time using TE Certified Electricians Split Payment discount

Install ceiling fan Replace burn outlet no warranty

For this job we did a leak detection service for homeowner and discovered leak in yard about 10 feet off the front right corner of the home. We excavated the water service. Customer has two leaks on a blue poly line age of home 2006.

Came out today to perform one system hvac service call. Upon arrival customer stated that the AC was not cooling efficiently. Upon inspection of the system found a 2020 Goodman heat pump, also found that the system was low on R410A, and the capacitor was out of range. Upon inspection of the indoor system found a Goodman air handler from 2020, the blower wheel to be clean, the indoor coil had some biological growth, there was no TE standard flood protection, also found that the Schrader valve on the indoor coil was leaking. Upon speaking with customer, customer elected to move forward with option A with the homecare plan. Upon completing repairs tested the system and everything was working properly. At this time system is up and running, see estimates for any further concerns.

Replaced the fluorescent tubes in two fixtures in the main area of the store with LED tubes, removed ballast from each fixture and rewired light.

Came out today to complete two system HVAC inspection. This is a vacant home. Upon inspection of the basement system I replace filter, cleared drain line, this system doesn’t have a pan flood protection, the refrigerant is completely gone reading 0 psi, the out door coil is dirty, this system also has no uv protection. The only way this system heats is from the heat strips, at this time the ac or heat pump heat will not work due to no refrigerant Upon inspection of the main level system replace 14x20x1, this system only has a bulldog pan switch which is not te standard for flood protection, all indoor components are clean and working properly, the outdoor system is working properly but the coil does need to be cleaned. At this time only the main level system is operating properly. See estimates for any further details

Called out for a backed up downstairs toilet. I pulled the toilet ran my cable throughout the line. Blockage was rust sewer supervisor to come by on Wednesday. Tested thoroughly line is open and flowing at this time. Thank you for choosing TE certified..

Service entrance repair

This estimate includes installing the customer supply transfer switch and plug in for the generator. This includes installing the whip coming from the transfer switch into the electrical panel, where we will reroute six different circuits and connect them to the transfer switch. Because of gas lines and water pipes the transfer, which will have to be 3 to 4 feet away from the electrical panel, and the whips for the transfer switches are usually not that long. We will have to make a tap box and install new wiring going from the tap box to the main electrical panel. As we arrive back here today, December 30, we’ve come back to fulfill the estimate of installing the transfer switch beside the electrical panel. We had to install a wood backing system to install the transfer switch on the wall next to the electrical panel. Once that was in place we installed the 10 circuit 50 amp transfer switch just to the right of the electrical panel. We made all circuits up in the transfer switch desi