Ellenwood, GA Electrician Plumber HVAC Service

The bare minimum basic repairs to get the system running today.

Troubleshoot

Arrived to install new txv, pumped down refrigerant into compressor, removed failed txv, installed new txv, brazed with nitrogen, checked for leaks, pulled vacuum, released refrigerant also added 4lbs r410a, checked pressures, temp split, unit working properly at time

Performed diagnostic on 6yr old carrier unit for main floor, upon arrival customer stated unit wasn’t cooling properly, checked both tstats, cycled to ac mode, unit started up, went in attic and inspected furnace, checked filter, blower , blower capacitor, airflow, checked both zones, recommended TE flood protection such as wet switch to help prevent water damage, customer approved , install new wet switch, inspected outdoor unit , found condenser coil impacted, recommend cleaning condenser coil, customer approved, chemical cleaned condenser coil, checked capacitor, found failed on condenser fan side reading 1, checked amp draw on condenser fan motor, found over amping , recommended replacing condenser fan motor and capacitor, customer approved, went to pick up parts, returned and installed new condenser fan motor and new capacitor, started unit up and rechecked pressures and temp split, after letting unit run system is showing signs of failing txv, recommended replacing txv for unit t

Based on our findings today, it might be time to think about getting a brand new system. System not cooling properly. Found filter very dirty and low on r22. And has a restriction. System struggles to keep cool in the heat of the day rising over 10 degrees. Duct work has multiple air leaks, and is over 30 yrs old. Lacking lots of insulation. Contactor is pitted and cap is poor. System does not have any warranty to it. Do not recommend repairs due to cost and warranty purposes. Coil is dirty as well

Client has us out today because she has a leak on her kitchen drain line, the leak is accessible from the outside of the home. The drain lines ran throughout the home are galvanized and are in overall rough condition. The bottom has rusted out in 2 locations within just a 5 ft stretch at the kitchen drain leak. Speaking with management we decided we are able to make a comfortable repair however we cannot leave a warranty on galvanized repairs. I am building a repipe option to update all drain lines to pvc. I presented options and today we went with just a repair. I cut out the galvanized section that was leaking and rep,aged it with pvc. Tested and there is no leaks. Client is happy with work performed, she is aware there is no warranty with the repair.

Performed diagnostic on main floor 10yr old unit, upon arrival customer stated unit wasn’t cooling and had water in pan that she had already removed, checked tstat, was off due to customer had power to unit off, turned on power, cycled tstat to ac mode, inspected furnace , found secondary drain pan and inside of furnace heavily rusted, recommend TE Flood protection wet switch, customer approved, install wet switch and tested, poured water in primary pan , all drained properly,checked blower wheel, blower capacitor, inspected evap coil, explained to customer it has rust as well and can cause leaks, checked outdoor unit, condenser coil impacted, recommend chemical cleaning, checked contactor, capacitor reading below specs, recommend replacing capacitor, explain weak capacitor can cause failure to compressor and condenser fan motor, checked amp draw, explain compressor is over amping and can fail at any time, recommended hard start kit to help lower amps, explained not a guarantee fix and

50 gallon electric

Performed diagnostic on 9yr old Goodman heat pump, upon arrival customer stated unit wasn’t cooling properly the other day so he went under house to check filter and found water, checked tstat,nest at 77 reading 77, set temp to 71, unit started up, went in crawl space, inspected ductwork, a lot has been replaced but supply plenum and return plenum in poor shape, recommend replacing both supply and return plenum, inspected air handler, found a lot of rust on bottom of casing also around evap coil, unit has water leaking from bottom, primary drain pan full of water, explained to customer drain line goes straight across the ground and has no fall so water sits in the pipe and cause sludge, which caused the drain to back up, recommend converting to a condensation pump, blower wheel heavily impacted, a lot of biological growth inside system, recommend apcox to help prevent future growth, blower capacitor reading below specs, recommend replacing, inspected outdoor unit, found coil impacted,

Troubleshooting several back bedroom outlets not working properly Troubleshooting Mom Little House Front Wall Sconces Saftey Concerns Inspection Customer meter main breaker is a 200a four wire electrical system The laundry room panel has 150a main breaker with three wire feeding the panel box With exterior mini home being fed with a 100a main breaker