Scottdale GA – HVAC, Plumbing & Electrical Service

For this job, I completed a two system AC inspection only. I measured all the electrical components of the indoor unit as well as inspected the blower wheel and all major components. Then proceeded to inspect the outdoor unit and measure all electrical components as well as get pressure readings and temperature readings. I explained all my findings to the customer as well as provided estimates. The main concern is that the upstairs unit is low on refrigerant not allowing the system to cool efficiently. I provided a bandaid option to just add refrigerant as well as an option to perform a leak test. The customers filter sizes are as follows: Upstairs : 16 x 25 x 1 Main floor : 15 x 20 x 1 or 16 x 20 x 1

Replacement of both plenums and the ducts. Media filter rack added on to the system. Only 900 cfm on supply and 480 on return was told to put back as is Flue was also rusted and discounted. I turned gas off so heat couldn’t run. Customer is awere

SERVICE CALL FOR LIGHT COMMERCIAL UNITS: Upon arrival customer stated both mini splits units Blue Ridge are not working properly on cooling Mode. After complete troubleshooting I found multiple issues on both Systems. The mini split for main office the Service Disconnect box was Bypass is not up to code check refrigerant charge pressures are extremely low perform courtesy electronic leak search and I found the indoor evaporator coil is leaking refrigerant unit is 7 years old contractor grade Due to aged and conditions I recommend to upgrade complete system. SMALL OFFICE UNIT: I found the mini split is in Poor maintenance conditions the indoor unit is leaking on the wall lot of condensation test Outdoor condenser unit check pressure are extremely low that’s why system ICE UP performed courtesy electronic leak search and aluminum evaporator coil is leaking refrigerant Due to aged and conditions plus costs of repairs I recommend to upgrade complete mini split. Compressor is

The bare minimum basic repairs to get the system running today.

Run new circuit for the furnace

Our client reached out to us in reference to a leaky shower faucet in the master bedroom. Client stated this Moen shower cartridge have been dripping for a while and needed it resolved. Client also had a blown expansion tank in an outdated water heater that he selected not to change. However, the expansiontank in the shower cartridge we’re both replaced and tested for leaks and no leaks were found.

The bare minimum basic repairs to get the system running today.

system inspection. Found no issues at this time. System is operating correctly with a 19.5 Delta T. Location of outdoor unit is directly underneath. The steps does not have 6 feet of clearance above it. Recommend moving unit to the side of the house to get full clearance and full accessibility to service outdoor unit. Based on our findings today, it might be time to think about getting a brand new system.

Completed home care inspection. System is a two year-old system. Inside unit is very clean. Customer stated that they were going to change the filter themselves. Upon inspection of the outdoor unit found debris inside of the unit and on the coils. Also found a bad capacitor. One presenting options to the customer, they accepted to proceed with changing the capacitor and cleaning the outdoor coils. All work is completed, and system is working properly.

Replaced failing thermostatic shower cartridge and located shut off for hose bibb

Replace mast and surge protector

Make all repairs necessary to restore the unit to full health and eliminate all other concerns. Replaced 2 ton heat pump condenser unit for upstairs level. Tested fully and found no failures at this time.

Disposal is not draining and is not turning on. I removed the unit and replaced. Ensured all connections were properly tighten. Filled the sink with water and released while turning on the disposal. Tested with no leaks.

Ac and coil

Tested system not cooling for the upstairs. System was flat on refrigerant and conducted a nitrogen leak test. Found the system was holding 305 psi with no issues and ended up finding the Schrader valve leaking from the low side service valve. We replaced a Schrader valve, pulled a proper vacuum on the system, and filled the system up with 7 pounds of refrigerant. Tested fully after repairs made, and found no failures at this time.

3 year old water heater not heating, temperature was set too high on heater and tripped reset button on heater. Turned temp back down to set 120 and reset heater. Water warming up read at 97 degrees in 30 minutes.

Jerilynn had us out today for a system inspection. Upon arrival we noticed there is a 28 year old system that had never been inspected. We noticed that there is no flood protection on the system and the 12.5MFD capacitor is out of range. We also noticed capacitor and contactor worn out along with the outdoor fan motor