Roswell GA – Electricians, Plumbers & HVAC Repair Service

Put both tankless water heaters up to code with an expansion tank on each cold line with a check valve on the cold and recirculating line. We also installed 2 ion 6’s. One on the cold side going to the heaters and one on the recirculating line.

Tech completed full inspection point check list… Tech left recommendations/ estimates that can help with equipment longevity, equipment protection and homeowners health and safety. Please review email, to respond to any estimates you can do so by email or calling in to reschedule appointments. *Thanks for choosing TE Certified if you liked your technician service today don’t hesitate to leave a 5 star review!

Dig/trench/pull from water meter to foundation to depth of 18". Lay new PEX/HDPE water service line in trench and connect at both ends. Install new dual check valve and meter nipple at meter location, as well as appropriate fittings at foundation tailout. If foundation penetration point is damaged, run new section of service line through foundation wall and protect. Seal interior and exterior penetration points with hydraulic cement. Test new line for leaks prior to backfilling trench to rough grade. Clean work area. Utilities will be marked prior to work. TE WILL REMOVE SECTION OF DECKING BOARDS AND CUSTOMER IS RESPONSIBLE FOR PUT BACK Work completed as described above. No new penetration was needed.

Came back on 04/08/26 Brought a new Lennox evaporator coil. Recovered refrigerant, braised in the new evaporator coil and new filter dryer. Pressure tested and found out that the new evaporator coil has leak. Went back to Lennox supply in Alpharetta and replaced the leaky one with a new evaporator coil. Braised in the new one. Pressure tested, system is holding pressure. performed a deep vacuum down to 589 microns. Recharged the system with 9lbs of refrigerant R-410A. System is back cooling properly at this time with 20 degrees delta T. Properly installed a wet safety switch.

Collected permit for work that will be done on return visit and made temporary repair till return visit.

Replace the main electrical panel in the basement. This option also includes the required code updates to bring the home to Roswell safety requirements. We will also install a customer provided EV charger with this option. Will need to do a return visit to install EV charger once homeowner provides EV charger and collect the remaining $500.

Installed contactor to prevent system from freezing up. Will return tomorrow with duct work to add to main floor and take apart outdoor condenser and chemically cleaned. Install 12 return cut in to main floor to bring system to 1180 cfms.

Run a home run to back porch outlet

Ac and coil swap out. Replaced two smart thermostats.

Troubleshoot light in laundry room.

System inspection completed. Minor wiring issue repaired that was preventing the air conditioner from coming on. Once the air conditioner came on, noticed that it is still not operating properly. The thermal expansion valve is beginning to have issues, and they’re also seems to be a restriction in the refrigerant line. Estimated repair costs could likely be getting close to replacement of air conditioner and coil. Due to the age and condition, the decision has been made to get a replacement estimate. Thank you for choosing TE certified!

Installed an Alpha comfort series pump and ionizer on water heater near theater. We previously installed both heaters last year. All work was tested and checked for leaks

Install 20a 120v circuit for workshop outlets. Install quad outlet at workshop Install twin breaker in electrical panel, to create space and supply new circuit. Add ground bar so that new circuit can be safely added only

One full system inspection Technician thoroughly inspected the unit above heat and cool from the thermostat Technician flush and clean the drain line and left the customer with 1 inch filter Technician static, and refrigerant pressures During the inspection, the technician found that the thermostat was out of date The blower wheel is dirty And the unit does not have TE standard flood protection

For this job we installed a new water heater disconnect above the rear bathroom ceiling. Old disconnect was melted and did not allow the handled to be pushed in on the hot side to turn the water heater on. New disconnect was installed and everything electrical issue functioning properly.

Misc home projects

Startup visit on Generac 48kw standby generator

Single system HOMECARE ** crawlspace 90% furnace ** changed filter and flushed drainage to which terminates in plumbing stack ** filter was very dirty / dusty …burners are showing signs of rust , noticed weak blower capacitor ** as a result made the appropriate option to fix issues …as always thank for you choosing TR certified **

.

Customer called us out for a blockage affecting the wash room and both bathrooms. On arrival water was coming up from a floor cleanout. I recommended running a flex shaft down the floor drain to clear the blockage. I removed the cover and ran the flex shaft down successfully clearing the blockage. Customer watched it clear from the outside. I then tested the drain by flushing the toilets and running water in the wash basin. I scheduled a sewer supervisor to come check the line for tomorrow 11-2. I also cleaned up the water on the floor.

Thank you for continuing to use TE Certified to help with your Home Care needs. For this appointment we finished your garage to multi use room remodel project. I’ve attached all the pictures taken throughout the process with this invoice. If you have any questions or if you experience any electrical issues, please contact me directly. If you would like help from any of our other professional tradesmen with 5% off your next home improvement solution, please contact our office and they will happily assist you. Thank you again for your time and the opportunity to serve you, your family, and home. Take care, stay blessed, and have a great retirement! -Luis L. 😁👍

Replace both shower cartridges in this shower one is a Delta 14 Monitor and the other is a Delta 17 Multichoice (17 Series RP46463) checked for leaks and verified that the cartridges were working properly.

Customer was experiencing a high water pressure. The old prv was covered over with dry wall. With customer approval I removed the old prv and installed a new one at a better location for future access. Once installed I test for leaks no issues was found thanks for choosing TE Certified.

Troubleshoot breaker tripping for hallway lights near garage

I came out to inspect an issue with the refrigerator, tripping the GFCI outlet. Because your refrigerator has a variable speed motor it can cause nuisance trips with a GFCI dual function breaker. In this case what I did was change out your dual function breaker to an arc breaker so it would still be up to code. I also installed a high frequency GFCI outlet at the beginning of the circuit, which should eliminate nuisance trips. If the GFCI continues to trip at this point, it is the refrigerator that has an issue as we discussed. I also opened up your panel to see if I could figure out if there was some issue with it being level that was causing that door to come open. The panel was slightly off level so I fixed that and it fixed the issue with the panel door. That door does have to be purposely latched, but now it does not come open unless you unlatch it. Thank you for using TE certified electrical! Veaya