Flowery Branch GA Electrical Service And Repairs

We install a new dryer outlet for customers new home

We are going to install 1” dimmable 2700k light on each ceiling. Each ceiling will have a total of 80 stars. All power will come from the laundry where it will be controlled my Lutron. 160 star lights on two dimmers sync through Lutron

Continue working on deck

Replace meter main combo

Came out to chain that had fallen off in toilet customer had toilet here to replace it

No warranty or guarantee that the breaker will not trip again due to just doing a band-aid repair

Fix two leaks on water heater

I replaced one existing bath fan with a new homeowner provided bath fan. I also left estimates to replacing lighting throughout the basement.

Completely finish the rough

Replace Customer supplied Light and Replace Switch in dining room

9/16 -- spoke with Wilson, this is pending an affidavit from the customer and they will reach out to schedule when that is signed, going to leave for now for an update from customer or Miguel -- AT 9/14 -- checking with tech on when this work is going to be completed. He is at this customer's location completing work today and tomorrow -- AT 24- lifx lights throughout ceiling 1- ceiling fan 72” dead center 2-4500w heaters in ceiling mounted 4- ceiling speakers 4- outdoor pool speakers 2- subwoofers 6-wall outlets 2- outlets for fridge Stair motion lights Tv mount over the bar This week we finished the rough stage

Diagnostic for main system. Outdoor fan was not running, low voltage wiring was not protected. Dirty condenser coil, filter and blower motor. Burned heat kit wiring, uninsulated lineset. Compressor is showing signs of failure. Burned and pitted contactor. Based on our findings today, it might be time to think about getting a brand new system.

Trouble shooting tripped breaker

Having the ninja on his own independence circuit, considering since it is the highest draw

After leak search was located by national leak detection, we returned to dig down, locate main water service burst on 3/4 HDPE, cut out section and made repair.

Remove old ejector pump me install new ejector pump Customer called us out because they were experiencing a failing ejector pump, float mechanism was not working anymore, causing basement fixtures to back up. Removed old pump and installed new ejector pump. Sealed all connections and fittings. After installation we checked system for leaks. Installation successful. Thank you for choosing TE Certified.

for this job, I came to look at a system that was not cooling due to the pan getting full of water. After a proper diagnosis, I was able to determine that the drain line was completely clogged, and the P-trap was incorrectly installed. I proceeded to provide an estimate for the customer to join our care, do a drain line repair and P-trap replacement, and also upgrade his flood protections. He just decided to get the P-trap replaced and the drain repaired. I proceeded to complete that repair properly testing the unit and pouring 2 gallons of water and vinegar down the drain. Thank you for choosing TE certified.

Removed coax wires from walls upstairs

Wire 24- lifx lights throughout ceiling 1- ceiling fan 72” dead center 2-4500w heaters surface mounted Electric fireplace 4- ceiling speakers 2- subwoofers 1- soundbar 2-wall outlets Lifx strip lights all around Strip lights on hand rails Stair motion lights Tv mount over the fire place 15- 2” wafer lights around the eve

Performed 1 system inspection for a system that is zoned for the main and upstairs. Found growth on the air handler and plenums, there was no bypass, no te flood protection, blower motor was clean, evap coil was clean,the drain line had improper pitch, the capacitor outside is failing due to the improper duct design and causing the compressor to draw higher amps as well. Recommend raising unit adding a pump and repair drain line pitch as well as adding a smart bypass damper. There is not indoor air quality products and would recommend the uv light, upgraded filter and an ionizer. Customer also interested in adding a new system for the basement level as well. Unit is operational at this time however not efficient. Based on our findings today, it might be time to think about getting a brand new system.

Replaced post guard filter cartridge.

Returned to install all necessary, water safeties for systems in attic. On the past visit I installed one wet switch for main. Today I installed. One wet switch and two SS2 water safeties. Now both systems in attic have a wet switch and SS2 float switch. Has one April air 213 and one April air 413 filters.

Replace light fixtures for hallway and laundry room, replace hallway bath fan

Today’s visit was for mold upstairs. When I arrived I checked the attic. It is extremely hot and humid in the attic. It has no ventilation and very poor insulation. The unit and ductwork is in the crawlspace. There is nothing in attic at all. Checked the indoor unit. Increased the fan speed. Also I found the filter extremely dirty. Customer approved me replacing it. Replaced the filter. Checked the cooling operation. The pressure checked good at this time. Checked the supply air temp and it was reading 51 degrees. The system is working as it should. I advised the customer to get the attic ventilation correct and get new insulation in the attic and it should help the house cool and maintain temperature. Thank you for choosing TE certified

Troubleshoot circuit dining room, replace outdoor outlet, replaced 20 amp breaker for a dual function, replace a mixed match breaker that was square D in the ITe panel