Johns Creek GA – Electricians, Plumbers & HVAC Company

Removed hose that was stuck on spigot. Replaced pressure reducing valve

Customer has 2 y/o 3-zone Lennox heat pump system that operates for whole house. System was not cooling due to failed dual capacitor. Replaced 45/7.5 MFD capacitor. Filter is clean. Drain line is clear. Dampers are operational. Recommend water protection upgrade. Recommend UV BlueTube for mold prevention. Pressure levels were normal. Coils are fair.

Customer has 19 y/o Carrier system that operates for upper level. System is not cooling due to refrigerant leak. R22 based system. Noticed during inspection that evaporator coil is rusted. Gas valve is also leaking. Run capacitor is bad. Blower wheel is dirty. Water protection is poor. Condenser coils are dirty. Informed customer of all findings. Based on our findings today, it might be time to think about getting a brand new system.

Pull and reset basement toilet and caulk base Installed high water alarm on sewer ejector system and test it Possibly remediation due to sewer flooding under carpets

SERVICE CALL: upon arrival homeowner stated the hvac system Is not working properly. After complete troubleshooting I found the third floor thermostat Honeywell failed. Customer stated he will order his own thermostat and will call us back to install the thermostat. Thanks for choosing te certified. Complete system is 2 Years old.

We were going to replace the check valve and install a high water alarm however after doing so we found the pump is also failing Today I Removed and replaced sewer ejector pump and check valve and bAll valve

The scope of today’s work included: replacement of existing hot water recirculation pump with a new Grundfos pump, rerouting of recirculation line for easier access and securing pump, a new 3/4” one way spring check valve on the incoming cold water line, a new 1/2” one way spring check valve on the recirculation return line, an air purge valve and a supply stop to isolate the line. We installed a new MOEN single handle shower cartridge and replaced a failed insta hot under the kitchen sink. Water was restored to the home, air was removed from the lines, air was purged from the recirculation line, all connections were checked for leaks, the shower valve and insta hot were tested and the new pump’s settings were configured for the home. At this time everything is working properly.

5/20: Sent chat to John in Teams to get futures. RW Replacement of 37) 2x2 flourscent to LED

Looked at customers pressure on her hoses couldn’t do much with all the customers there told her be better to reschedule when no one‘s there using the water so I can get accurate readings

The bare minimum basic repairs to get the system running today. Return visit complete ** changed exiting damper and installed EWC 10 inch smart bypass damper ** tested system and set damper accordingly ** system operating post repair today **

Found 2022 single stage Lennox zoned system with a secondary drain pan with water in it. Found that the unit is 3.5 ton system with no bypass damper and slightly short on duck work. System needs a bypass damper to prevent the unit from freezing up. Unit is potentially freezing up when AC runs and not all the zones are open I verified that the drain line was not clogged and added a clean out T. I checked the zoning diapers and board. I checked the contractors and capacitors and the refrigerant pressures. I verify that the blower motor, condenser fan motor and compressor were all operating. The wire running to the air handler from the disconnect is under sized; 8 awg needs to be 6 awg copper wire (10 kw strip heat). The system needs better flood protection and approx 1 lbs of refrigerant. A UV light is recommended as well because system does have a small amount of black biological growth growing in the air handler. I went over the finding with the homeowner. Ideally system should be a va

Installed smoke detectors in bedrooms, installed wires. Replaced smokes detectors in hallways. Replaced breaker for dual function breaker to smoke detectors upstairs.

Travel charge

Performed routine inspection on 6 y/o Goodman system that operates for main and upper levels. Checked amp draws. Cleaned flame sensor. Cleared pressure switch tubing. Blower wheel cleaning needed. Water protection upgrade recommended. Drain line pitch is incorrect. Suction line insulation inconsistent. Water-stained secondary drain pan. Recommend thermostat upgrade. Ductwork/plenums are dirty, in poor condition, and undersized for system. Head pressure is high due to dirty condenser coils. Disconnect is not properly secured along with whip. Exterior drain line not properly extended. Performed routine inspection on 31 y/o Trane heat pump system that operates for basement level. Heat strip kit in poor condition. Evaporator coil is rusted and dirty. Filter very dirty. No water protection present. Condensate drain pump aged. No secondary drain pan. Blower wheel very dirty. Blower motor has significant buildup. Run capacitor is bad. R22 based system. Compressor is reading high amperage. Co

Replace 37 2x2 light fixtures

Troubleshooting

Remove and replace shut off valve under outdoor kitchen on cold side. It had failed due to freezing temperatures and they just started using and noticed it leaking

Performed 1 system home care. System is zoning with 2 zones for main floor and upstairs. Checked and replaced dirty filter 16x25x4 which customer provided. Checked and cleaned flame sensor. System has dirty blower wheel. Also System has proper Te flood protection. tested safeties and are operating properly. Tested cool and checked delta T of 18°. Also Checked electrical for indoor and outdoor and Noticed outside capacitor is out of tolerance. Everything else is up to manufacture standards. Treated drainline with endure and used mighty pump outside to clear drainline. Left customer options to replace capacitor and do cleaning for blower wheel. For today performed all necessary replacing dual capacitor and cleaning blower wheel. Make all repairs necessary to restore the unit to full health and eliminate all other concerns.

Estimate is to replace main level HVAC system, media filtration system and permit all work with Johns Creek.

Rebuilt toilet for commercial salon.

Replaced 10 existing breakers with new homeowner provided dual function breakers (2 15s and 8 20s). New outlet for a bidet toilet seat was added in the master toilet room and was tied off of the master bedroom circuit. I discussed with the homeowner the potential of the lights flickering when the bidet is on full power since it pulls about 12 amps, but he was fine with this and we talked about running a dedicated circuit to the outlet if issues present themselves.

Leak from free standing tub in primary bathroom Found no leak on drain or on faucet Cut drywall to access pipes to check for leaks Water from hand sprayer and from splashing on floor is causing water to leak through the uncaulked seam behind the tub where tub meets floor Recommend to caulk entire back of tub and around faucet plate to stop water from leaking through Due to tub/faucet design, it’s recommended to hang hand sprayer over tub edge to drain into tub after every use until it stops draining out Also try to keep the water in the tub when kiddos are bathing

Provide detailed estimate for system corrections & upgrades to adjust airflow

Troubleshoot

For this job we troubleshot a tripping arc fault breaker. And the inspection we determined the middle pendant light on the front porch had gone bad. Unwired the light and put it back up as customer was taking pictures to sell the home. Left estimates to replace it.