Braselton GA Electrical Service And Repairs

Installed Ethernet Lines throughout home Installed Outlets inside the pantry and hallway Installed whole house surge protection Installed Internet Switch device

Gas company tested home and said there is a leak on the homeowners side of the gas meter. Pressure tested home to find where leak is.

Replace 21yr old smokes

Return to trim out outlet and fixtures

Replacing 50 gallon gas water heater, installing Recirc pump & comfort T, new washing machine box, installing 2 cs toilets including new supply lines, wax rings & nylon bolts, pulling and resetting 1 toilet, testing for leaks, testing pressure

Replace bad gfi in powder and Burnt outlets in master and up bath

Performed HomeCare maintenance on two systems. Main floor system has no wet switch in pan, no ss1 on condensate drain, rusted out evaporator coil, low on 410a, dual capacitor is out of manufacture specs, and condenser coil is dirty. Basement system has no form of water safeties wired into the system.

Pull and reset toilet. (Only 1 toilet in the space) Shim and caulk toilet

Figure out why outlet is burnt and why outlets is bathroom do not work

Tap into outlets from master bedroom underneath the windows. Dig trench and run wire in conduit to gazebo. Install two outlets at the bottom of the pillar. Install one decora and one stacker switch to control lighting and ceiling fan. Wiring for sconces and ceiling fan done by others. Install gfi outlet for outlet to the right of the back door in place of standard duplex receptacle . Existing outlet wasn’t gfi protected. Tap off outlet in master bedroom for tv outlet outside to the right of the back door. Replace two outlets in the master bedroom under the windows. Install safety monitoring breaker for the circuit( Master Bedroom and gazebo . Add a single pole breaker for the other circuit that was on the tandem breaker. Troubleshoot sconces not working on gazebo. Made homeowner aware of safety concerns with challenger panels. Neutrals and grounds are also double tapped in panel. SER was ran from standard meter to the panel, the installer cut the ground at the connector. Provide multi

Dimmer Switch in dinning room

Added circuit for Fridge

Tested system not cooling due to a failed damper motor for upstairs zone. Today we replaced the damper motor and upsized the 10” bypass to an EWC smart bypass. Fully tested the system after repairs and no failures at this time.

Remove original Rheem heater booster and repipe all water lines above water heater and also install new expansion tank and strap. Flushed heater as well. Turned hot water heater on to test and ensure proper function.

Rebuilt a Koehler toilet to fix a leak between the bowl and the tank

Replaced Light in Dinning Room

Came in for a no cool call. Outdoor condenser was not running due to a fail, capacitor motor. This occur due to system having to work because evaporated was completely clogged and was now getting proper airflow so system has to overwork to compensate the missing air, damaging system electrical components. House notice the dog was completely caked up, and there was signs of biological growth spreading through system. Also, condensate pump had failed over pouring water inside the crawlspace. Let customer know about these issues and presented options. Customer decided to move forward with repairs, but he is aware that duct work needs to be redone and that air flow in the house will not be as efficient as upstairs system. Work was done and tested, system is now working properly. Thank you for choosing TE Certified!

For this job, I worked on installing a new ceiling fan from scratch, adding a switch leg going up to the fan along with adding a retrofit fan box

Installed new faucet to match with customer trim, customer purchased a faucet and was unhappy with the color so we picked a new one for, no,e depot and she sent me to HD with her card to purchase I returned and installed

SERVICE CALL: Upon arrival homeowner stated the second floor hvac system is not working at all and the ecobee thermostat was completely Blank. After complete troubleshooting I found the main drain line Was clogged and overflow and open the wet switch. Customer approved Repairs and clean main drain line and removed the water inside the unit And replace and install new wet switch under warranty. Flushed both drain lines with 2 gallons of water test cooling mode system is working ok at this moment. Thanks for choosing te certified Recommend routine maintenance and new pleated filters.

Troubleshoot dishwasher/ install new 15amp breaker dual function

Rebuild 3 toilets and reset toilet in office

water heater flush/install new flush handle in guest bathroom/cut in new drain for washing machine pan upstairs laundry attach drain outlet

Troubleshoot outlets not working in bathrooms

Replace flush mount lights and install two ceiling fans for bedrooms