Dallas GA Electrical Service And Repairs

Returned to replace compressor. Refrigerant was first recovered and then nitrogen was flown while unbrazing and installing compressor and filter drier. System was then pressure tested and vacuumed to 500 microns. New refrigerant was weighed in and system was started up. Refrigerant levels were then adjusted to meet manufacturer specifications. Changed out 45/7.5 as a precaution. Upon startup is was discovered that the TXV was also bad. Talked to customer and we agreed to replace the valve for a discounted rate. Valve was changed and system was charged and verified to be fully operational. Changed out filter as well.

Ran circuit for car charger on the exterior of the home between the garages, had to lower the charger it’s self to 30 amp due to load calculation on the home, also installed surge for protection.

Flush water heater and dispatch fee. Flushed water heater and check ice maker line for contaminants. Advised customer to call appliance company to service refrigerator as water line is working optimally.

Water was leaking in garage ceiling and TE cut dry wall and exposed pipes and the leak wasn’t dripping from pipes.Water will drip down from the outside edge of the tub.

Came on 05/01/26 and properly replaced the dryer vent flex with single wall vent pipes. Tested dryer, and dryer is venting air outside. No issues or concerns.

Replaced switch in master bathroom that failed

Homeowner reported low water pressure. Inspection found little to no pressure on the hot side due to a leaking water heater, along with a leaking pressure reducing valve (PRV). Additional issues included corrosion and minor leaks in the kitchen drain system. Repairs completed included replacement of the electric water heater, PRV, main shut-off valve, garbage disposal, and rebuild of the kitchen drain system, along with new angle stops. System was tested after repairs, confirming proper operation, no leaks, and restored water pressure. Homeowner approved and satisfied with work performed.

Troubleshot one of the kitchen circuits not working and replaced a dual function breaker.

Troubleshoot light not working.

Troubleshoot lights not working.

Upon arrival, met with customer and spoke with her regarding their issue. Customer showed me inside and to the main level kitchen. Customer states disposal is not working and she also purchased a new kitchen faucet that she would like installed. The disposal had rusted through and I presented the customer with options to install a new disposal and kitchen faucet. Customer agreed and after getting signature approval I began work. During the process I noticed the supply lines for the old faucet were integrated with the stop valves. Informed customer that the stops would need to be replaced in order to install the new faucet. Presented customer with add on price for the stops. Customer agreed and after acquiring the stops I replaced those as well. Finished installing new disposal and faucet. Thoroughly tested for leaks and proper function. No leaks. Cleaned work area. Customer is satisfied.

For this job, I ran three new circuits for the island and installed several outlets for pop up outlets and appliances.

Customer called us out for a garbage disposal in the kitchen that was not turning on. I inspected the disposal and found that it was jammed from rust and also not draining. I recommended replacing it and the customer chose the 1/2 hp badger. I removed the old disposal and installed the new one. Tested it and checked for any leaks. Cleaned area throughly cup the area throughly.

I came out to check where the plug on neutral type breaker in the service disconnect was feeding. I used a toner and traced it back to the back porch which is feeding the lights and fans. I supplied and installed a new duel function breaker that is designed for the service disconnect that feeds power to the back porch. After installing the breaker I went to the back porch and turned all the switches on to verify that everything was working and issues are present.

Replace customer provided breaker.

Replace customer provided breaker

Replaced thermostat that customer supplied. New thermostat are Honeywell digital/ WiFi. Tech did not setup WiFi to thermostat due to customer selling the home. After installing thermostats tech tested and checked out hvac system. The following tech came a crossed. Main level is a r-22 with over amping compressor , condenser is needing a chemical cleaning. System has been over charged With Freon. Tech is unable to adjust charge due to the type of Freon in system. There is no repairs that are available to keep system in operation Indoor Blower is needing a cleaning. Filter is needing to be changed evaporator coils are rusted. Upstairs system. 410 a system. Blower wheel is needing to be cleaned. Filter is needing to be changed. Drain Line is needing to be cleared. Wet switch is needing to be added to system. Condenser is needing to be cleaned chemically and contactor is needing to be replaced. Spoke with customer about issues tech has came a crossed. Due to customer selling home cu

The homeowner reported experiencing lukewarm water. As part of our diagnostic process, we consulted with the manufacturer and performed a thorough evaluation of the water heater. Based on our findings, we determined that the thermostat within the gas control valve was no longer functioning properly. We presented the homeowner with both repair and replacement options, and she elected to proceed with replacement of the gas control valve. After completing the installation, we tested the system to ensure proper operation and confirmed that there were no leaks. The unit is now functioning as intended.

Replaced breaker and troubleshoot why it’s tripping.

Troubleshoot: I came out today to troubleshoot an open neutral issue with the dining and breakfast outlets, I found a bad connection at an outlet in the dining room where a back stabbed connection was. While completing the work I discovered a buried junction had been installed to move this outlet location over and the original location was mudded over. I installed a new location outdoor outlet behind the original outlet location to access the buried junction and was able to remove the original box and remake the connections in the new outside outlet box permanently fixing the issue for the dining and breakfast area outlets.

Safety list

Moved gas line for kitchen stove.

For this job, I completed part of a kitchen remodel. I moved some wires in the floor for the new island location and I relocated a switch box.

EV charger

Replaced and installed 6 yr Electric Water Heater. We also ran a new T&P relief line to the exterior of the home. All work was tested and checked for leaks.