Dawsonville GA Electrical Service And Repairs

For this job we installed four customer supplied ceiling fans in the basement bedrooms, living room, and master bedroom. Also installed customer supplied fixtures in the dinning room, over the island, and in the basement. Replaced two incorrect breakers with the correct GE breakers. Will make a return visit to install new oven outlet and hand a new fixture on the foyer that has not arrived yet.

New shower drain with seal installment for upstairs bathroom

Called out last night to replace water heater went to Home Depot. Got new water heater installed water heater during filling water heater last night discovered a leak that was coming from the tank of the water heater so came back this morning. Took the new tank back to Home Depot swapped it out for a new water heater. Got water heater installed water heater is heating. There are no leaks at this time thank you for choosing TE certified.

2026 homecare

My client reached out to us regarding 2 issues: one being a dripping tub spout and the other being a leak at a bladder tee for a well system. Called the manager who mentioned it would be best to have a team that specializes in wells make the repair on the 26 year old system. TE certified does not currently make repairs on or replace well components. Replace the shower cartridge in the basement bath with a new delta monitor cartridge. Replace shower trim with CS delta furniture. Purchased a tub spout compatible with the hardware that was sweated on the tub stub out. Checked for leaks and verified proper operation. I reported a leak to the customer: upon turning water back on to the home, I noticed a dripping from the home sediment filter which did eventually stop. We believe it’s just a failed seal but my client is going to keep an eye on it for now. I double checked and didn’t see any leaking from this point before I left. A quote was not wanted

Install new flood lights and replace one GFCI device

Tesla EV installation

At arrival on 02/21/26 found whole home system not heating due to bad thermostat, bad outdoor unit capacitor. Improper drain line, no wet safety switch. Microbial growth in plenums, dirty air ducts. Homeowner approved to address most issues. Properly performed the job.yh The bare minimum basic repairs to get the system running today. Make all repairs necessary to restore the unit to full health and eliminate all other concerns.

Homeowners are experiencing a leak in the front yard near the water meter, closer investigation shows it was an electronic valve on the irrigation side. An irrigation company would have to resolve this. While TE works on irrigation line repairs, we do not fix these or sprinkler heads. I shut off a valve that supplied water to this unit in the meantime: there may be some residual water that seeps out of the leaking component but will stop as pressure in the system decreases. Water heater is from 2021, water pressure is at 65 PSI

We replaced the main electrical panel due to the old, one being damaged with burn marks. We brought the remainder of the home up to current electrical code by installing hardwired smoke detectors, installing a whole home, surge protector, installing a new grounding system, and installing ground fault protection where needed

No heat/ mainfloor system. I Found a blown fuse and low voltage short. I fixed the short and replaced the fuse. I cleaned both outdoor condensers and tested the systems. I flushed the drain line with water, enzymes and clean out tablets. I found biological growth on the mainfloor system. I installed a blue tube UV light and an Iwave in the mainfloor air handler. Both systems were operating when I left.

Install new Rheem select heat pump system for basement Install new supply and return plenum Install new supply lines and new return lines Mastic seal equipment connections Install new 50ft Lineset drain line and condensation pump Install new thermostat wire and customer provided thermostat Install new outdoor pad and electrical disconnect Install all new boots and registers System start up

Customer had a main line blockage that was affecting the entire upstairs bathroom group, customer recently moved in the second blockage that affected the entire upstairs had the septic tank pumped not too long ago, I pulled the toilet upstairs and ran my cable down the main line to clear the blockage after I ran my cable I was able to poke free. The blockage on all the water was draining after testing. All the water is flowing perfectly scheduled for a camera inspection since it’s the second time affecting the upstairs and they will run the camera from the same toilet I pulled. I did not set the toilet all the way back recommend that the customer do not use the toilet until inspection is completed. Customer do have another bathroom upstairs that they can use. I have the toilet over the flange and bolted to the floor, but no water is connected to make it easier for the camera tech to pull the toilet.

On arrival, it was explained that the water bill had increased. The water company says there is a steady 8 gallons an hour being used. upon investigation, we discovered 100 psi inside the home and no thermal expansion protection. After much investigating the only thing that could be determined at this time was due to the high pressure the master bedroom toilet fill valve had failed. After providing options upon approval, we replaced the pressure regulator, added a thermal expansion tank properly, mounted to the structure of the home and rebuilt the master bedroom toilet. we also replaced the isolation valve for the water heater and re-ran the piping on the cold side going to the water heater in order to get rid of a few inches of polybutylene. We also installed a new whole home shut off valve. Tested everything for leaks and proper function.

On arrival, it was explained that the water bill had increased. The water company says there is a steady 8 gallons an hour being used. upon investigation, we discovered 100 psi inside the home and no thermal expansion protection. After much investigating the only thing that could be determined at this time was due to the high pressure the master bedroom toilet fill valve had failed. After providing options upon approval, we replaced the pressure regulator, added a thermal expansion tank properly, mounted to the structure of the home and rebuilt the master bedroom toilet. we also replaced the isolation valve for the water heater and re-ran the piping on the cold side going to the water heater in order to get rid of a few inches of polybutylene. We also installed a new whole home shut off valve. Tested everything for leaks and proper function.

On arrival, it was explained that the water bill had increased. The water company says there is a steady 8 gallons an hour being used. upon investigation, we discovered 100 psi inside the home and no thermal expansion protection. After much investigating the only thing that could be determined at this time was due to the high pressure the master bedroom toilet fill valve had failed. After providing options upon approval, we replaced the pressure regulator, added a thermal expansion tank properly, mounted to the structure of the home and rebuilt the master bedroom toilet. we also replaced the isolation valve for the water heater and re-ran the piping on the cold side going to the water heater in order to get rid of a few inches of polybutylene. We also installed a new whole home shut off valve. Tested everything for leaks and proper function.

On arrival, it was explained that the water bill had increased. The water company says there is a steady 8 gallons an hour being used. upon investigation, we discovered 100 psi inside the home and no thermal expansion protection. After much investigating the only thing that could be determined at this time was due to the high pressure the master bedroom toilet fill valve had failed. After providing options upon approval, we replaced the pressure regulator, added a thermal expansion tank properly, mounted to the structure of the home and rebuilt the master bedroom toilet. we also replaced the isolation valve for the water heater and re-ran the piping on the cold side going to the water heater in order to get rid of a few inches of polybutylene. We also installed a new whole home shut off valve. Tested everything for leaks and proper function.

On arrival, it was explained that the water bill had increased. The water company says there is a steady 8 gallons an hour being used. upon investigation, we discovered 100 psi inside the home and no thermal expansion protection. After much investigating the only thing that could be determined at this time was due to the high pressure the master bedroom toilet fill valve had failed. After providing options upon approval, we replaced the pressure regulator, added a thermal expansion tank properly, mounted to the structure of the home and rebuilt the master bedroom toilet. we also replaced the isolation valve for the water heater and re-ran the piping on the cold side going to the water heater in order to get rid of a few inches of polybutylene. We also installed a new whole home shut off valve. Tested everything for leaks and proper function.

On arrival, it was explained that the water bill had increased. The water company says there is a steady 8 gallons an hour being used. upon investigation, we discovered 100 psi inside the home and no thermal expansion protection. After much investigating the only thing that could be determined at this time was due to the high pressure the master bedroom toilet fill valve had failed. After providing options upon approval, we replaced the pressure regulator, added a thermal expansion tank properly, mounted to the structure of the home and rebuilt the master bedroom toilet. we also replaced the isolation valve for the water heater and re-ran the piping on the cold side going to the water heater in order to get rid of a few inches of polybutylene. We also installed a new whole home shut off valve. Tested everything for leaks and proper function.

On arrival, it was explained that the water bill had increased. The water company says there is a steady 8 gallons an hour being used. upon investigation, we discovered 100 psi inside the home and no thermal expansion protection. After much investigating the only thing that could be determined at this time was due to the high pressure the master bedroom toilet fill valve had failed. After providing options upon approval, we replaced the pressure regulator, added a thermal expansion tank properly, mounted to the structure of the home and rebuilt the master bedroom toilet. we also replaced the isolation valve for the water heater and re-ran the piping on the cold side going to the water heater in order to get rid of a few inches of polybutylene. We also installed a new whole home shut off valve. Tested everything for leaks and proper function.

On arrival, it was explained that the water bill had increased. The water company says there is a steady 8 gallons an hour being used. upon investigation, we discovered 100 psi inside the home and no thermal expansion protection. After much investigating the only thing that could be determined at this time was due to the high pressure the master bedroom toilet fill valve had failed. After providing options upon approval, we replaced the pressure regulator, added a thermal expansion tank properly, mounted to the structure of the home and rebuilt the master bedroom toilet. we also replaced the isolation valve for the water heater and re-ran the piping on the cold side going to the water heater in order to get rid of a few inches of polybutylene. We also installed a new whole home shut off valve. Tested everything for leaks and proper function.

On arrival, it was explained that the water bill had increased. The water company says there is a steady 8 gallons an hour being used. upon investigation, we discovered 100 psi inside the home and no thermal expansion protection. After much investigating the only thing that could be determined at this time was due to the high pressure the master bedroom toilet fill valve had failed. After providing options upon approval, we replaced the pressure regulator, added a thermal expansion tank properly, mounted to the structure of the home and rebuilt the master bedroom toilet. we also replaced the isolation valve for the water heater and re-ran the piping on the cold side going to the water heater in order to get rid of a few inches of polybutylene. We also installed a new whole home shut off valve. Tested everything for leaks and proper function.

On arrival, it was explained that the water bill had increased. The water company says there is a steady 8 gallons an hour being used. upon investigation, we discovered 100 psi inside the home and no thermal expansion protection. After much investigating the only thing that could be determined at this time was due to the high pressure the master bedroom toilet fill valve had failed. After providing options upon approval, we replaced the pressure regulator, added a thermal expansion tank properly, mounted to the structure of the home and rebuilt the master bedroom toilet. we also replaced the isolation valve for the water heater and re-ran the piping on the cold side going to the water heater in order to get rid of a few inches of polybutylene. We also installed a new whole home shut off valve. Tested everything for leaks and proper function.

On arrival, it was explained that the water bill had increased. The water company says there is a steady 8 gallons an hour being used. upon investigation, we discovered 100 psi inside the home and no thermal expansion protection. After much investigating the only thing that could be determined at this time was due to the high pressure the master bedroom toilet fill valve had failed. After providing options upon approval, we replaced the pressure regulator, added a thermal expansion tank properly, mounted to the structure of the home and rebuilt the master bedroom toilet. we also replaced the isolation valve for the water heater and re-ran the piping on the cold side going to the water heater in order to get rid of a few inches of polybutylene. We also installed a new whole home shut off valve. Tested everything for leaks and proper function.

On arrival, it was explained that the water bill had increased. The water company says there is a steady 8 gallons an hour being used. upon investigation, we discovered 100 psi inside the home and no thermal expansion protection. After much investigating the only thing that could be determined at this time was due to the high pressure the master bedroom toilet fill valve had failed. After providing options upon approval, we replaced the pressure regulator, added a thermal expansion tank properly, mounted to the structure of the home and rebuilt the master bedroom toilet. we also replaced the isolation valve for the water heater and re-ran the piping on the cold side going to the water heater in order to get rid of a few inches of polybutylene. We also installed a new whole home shut off valve. Tested everything for leaks and proper function.