Snellville, GA Electrical Service And Repairs

Customer has the sink snaked on the eighth of September, It backed up again today when they ran the dishwasher up upon arrival, I ran the sink and the line was backing back up, We would Collect a difference if it backed up again between the cable, they paid with Eric and the Hydro Jetter today per Eric, After the Hydro Jetter chunks of grease was coming back, but I was able to clear the blockage. Customer denied bottom of end said they will buy green goblin from Home Depot. After testing, no leaks was present, and water was flowing perfectly

Upon arrival, found leak at p-trap fitting in kitchen. Tested safety features on plumbing system and found that water pressure is 110 PSI. Customer not interested in hearing any options to resolve pressure to home.

Replace old bath fan with customer provided bath fan

Outlet replace

For this job, it was required me to replace a defective PRV that was causing the water pressure to pulsate when multiple fixtures were in use in home. Prior to replacement the water pressure 60 psi which was throwing things off. But the defective valve has been replaced as well as an old gate valve. Two ball valves have been installed on the system all workers document with photos. All items for leaks and no leaks were found. Water pressure after valve replacement was 60 psi and our client is very happy!

Installed 4 new wafer lights in master bedroom

Repair sewer line at 6” sanitary tee due to back pitch of pipe. Remove sod and set aside. Install clean out

Full system installed New smart thermostat installed 2 new plenums built New Apco UV light installed New drain pan New outdoor pad New whip New condensate pump New media AprilAire cleaner

Electrical panel replacement 08/28 Reached out to schedule Left a VM *KS Install EV charger in garage

Run k400 in kitchen sink and clear blockage in kitchen sink. Customer was experiencing a slow draining kitchen sink due to grease buildup. Ran k400 cable in drain and we were successful at clearing blockage. Tested multiple times and clearing was successful.

System is sweating due to it not having enough duct work. Customer needs 1600 cfm for their system, but only has 1000 cfm. I also noticed that there’s no ss1 on drain, recommend wet switch to ensure no water issues, system is leaking airflow and needs to be sealed, blower wheel is dirty, flue pipe is not up to code, and condenser coil is dirty. Heat exchanger has some rust build up on it, but no cracks at this moment.

Installed new Tesla EV universal charger

For this job, I completed a one system full inspection. I tested the unit in both heat and cool to ensure that everything was working. I inspected the coil, blower wheel, and burners and measured all of its electrical components. I then proceeded to inspect the outdoor unit and all its electrical components as well as get pressure readings. I explained all of my findings to the customer as well as provided estimates. What’s important to note is that the unit is from 1995 way over its life expectancy.

Installed new water service line with 2in sleeve. Began at sidewalk and ended through concrete in front of the water heater. Installed new prv.

Install customer supplied dimmer Re do connections for switches

Leak search

Shower handle in the master bath is difficult to turn. Shut off the water and drain the water lines, removed and replaced the cartridge with a client provided cartridge. Turned on the water and pressurized the system. The handle is now turning with ease. Water pressure to the home is 55psi.

Replaced water heater, prv, w/h vent and t&p line. Installed warranty extension kit. Homeowner to call in 1 week to schedule inspection.

Remove existing basement toilet. Remove pump system. Remove concrete in basement bathroom and under stairs. Excavate area. Install new sewage ejector pump basin, pump, and PVC pipe and fittings servicing basement bathroom. Backfill and tamp. Pour new concrete to rough finish. Install new ejector pump discharge. Remove and replace water heater. Replace improperly installed gas line servicing water heater. Remove polybutylene pipe throughout home. Install new PEX pipe and fittings. Replace washer box and ice maker box. Replace all angle stops. Replace shower faucets (customer to provide Delta faucet trim kits). Replace main water shutoff valve and pressure regulating valve in basement. Install new whole house water filtration system and water monitoring valve. Replace 2nd floor hall and master toilets. Basement toilet will be left at home to be installed after flooring is installed.

Replace 5x security lights

SYSTEM RECENTLY FROZE; FOUND LOW REFRIGERANT LEVELS. CONDUCTED ELECTRONIC LEAK SEARCH & FOUND EVAP COIL IS LEAKING! FLUE PIPE IS SINGLE WALL & IN POOR CONDITION. HEAT EXCHANGER IS ALSO RUSTY & IN POOR CONDITION AS WELL. STARTING COMPONENTS ARE OLD BEGINNING TO FAIL BASED ON READINGS. COND. COIL IS VERY DIRTY! Based on our findings today, it might be time to think about getting a brand new system.

Troubleshoot gfi at front entrance, to the right if the panel. Replace gfi and bubble cover.

Performed home care on two systems. Checked all electrical and amperage. Cleaned flame sensors. Flushed and treated drain lines. Changed the filter for upstairs unit 14 x 25 x 1 filter in addition was replaced in July 4 inch filter did not need to be changed. Checked outdoor units. Checked capacitors, contactor and pressures. Checked both heating and cooling. All systems operating. Second floor unit does not have in-line safety or wet switch. And dirty blower wheel. Unit in addition bad pitch on drain line and dirty condenser coil. Also, customer only has home care on one system. For addition in back of home.

Panel replacement

The customers water heater was leaking from what appeared to be the drain port threads. I was unable to perform any diagnostics due to the gas meter being locked, he will have the gas company come out Friday and turn on the gas meter. The customer also had us replace a fill valve in one of their toilets, the customer also told us that there is a lot of pressure fluctuation, the thermal expansion tank is full of water, the customer will have us return Friday to provide full estimates