TE Certified is dedicated to providing the highest quality home-care services in the Cumming GA area.

For this job, I installed a 1.5 ton Ac&Coil for the upstairs. As well as a 3.5 ton Ac&Coil for the main level.

Upon arrival, customer notified me that he would like to have two of the lights over the island replaced with customer provided light fixtures. We would like to have these lights on a dimmer switch. We would also like to replace the dining room chandelier with a new one and would like to have a dimmer switch install installed on this fixture We are going to replace the living room chandelier. There’s currently no dimmer at this location and we would like to have a dimmer switch. Customer would like us to install two new sconce lights by the front door. There is no access for attic or basement without creating damage. We will have to route a wire from the existing three gang switch box to the desired locations most likely going through the basement to avoid framing from the front door. We would also like to have two new sconces lights installed in the dining room location. Customer would like to have an option to have a dimmer switch installed on the dining room lights. There is no

Install new lights

We installed a new gas water heater in a pan on the ground with expansion tank and we changed single wall 3” venting to double wall venting. Thank you !

Completed HC inspections Cleaned upstairs, master bedroom and basement condenser units. Installed turbo cap and superboost on upstairs AC.

Upstairs part of the house blows air , even when thermostat satisfies the temperature set. Motor damper is stuck opened. Tested system in heating and cooling with no other issue. No flood protection device installed. Also, recommend to install a blue tube uv light, to give better air quality to the house, and to protect equipment from growing biological growth.

Installed a new Rheem 50 Gallon natural gas water heater. We moved the water heater 4 feet to the right to allow for more shop space. Installed new water lines, shut off valve, expansion tank, gas valve, flex connector, sediment trap, relief line, drip pan, and leak alarm. We converted the exhaust vent and the fitting it ties into from single wall to double wall piping. All air was purged from the tank and water piping. Water heater has been lit and is set to 120 degrees. Thank you for choosing TE Certified!

Today we came out for main level not heating 2020 carrier 45k carrier furnace with matching 3 ton ac builder grade. Cycled equipment from thermostat found failed variable speed motor module and failed circuit board. In addition system is a three ton and there is not enough return duct. Client has three 10” returns and needs one more. Called carrier to check on warranty status and builder did not register equipment taking warranty from 10 year to a 5 year. All plenums in attic are ductboard fiber glass. Gave client repair options and scheduled install supervisor to give options on updating furnace. Left main level system out of service.

Performed 2 system homecare. Recommended having quotes on 20+ heat pump that serves the finished basement. Homeowner said power bills were really high due to her pump only using heat strips to heat the home. The R22 is low and will cause unit to freeze up. Upstairs blower motor is over amping and could hear the bearings are failing. Recommending replacing basement heat pump. Replacing upstairs blower motor. Water safety switches on upstairs equipment. Adding return air to upstairs system.

Install (4) new smoke detectors in each of the bedrooms upstairs. Install arc fault breaker for smoke detector circuit. Gfi protect the following circuits with (5) dual function/gfi breakers : attic,disposal,dishwasher,fridge,washer. Replace bath fan motor upstairs with new motor and trim. Replace dimmer with new LED dimmer upstairs. Replace back porch outlet with new weather rated gfi and bubble cover. Install outlets and appliance cords for dishwasher and disposal. Update grounding system with additional ground rod and wiring.

For this job, we installed 4 return and 2 supplies for the main level as well as the upstairs unit.

Today we came out for main level not cooling Goodman 2016 2 ton ac builder grade. Cycled equipment from thermostat checked operations found condenser fan motor running but compressor did not energize. Checked duel motor starter found 45 reading 41. Compressor is locked up gave customer band aid option and scheduled install supervisor to give options. Installed hard start kit compressor energized checked refrigerant levels found them to be critically low. System has major refrigerant leak which has damaged compressor. System could fail at anytime.

Installed whole home surge protection

No heat on the min level system, due to a bad gas valve. Will need to replace the gas valve, in order to do a complete diagnostic. Sent estimates to replace gas valve. Customer will call us back, if she wants to go with us for this repair.

Homecare inspection 2 systems. Checked electrical components, checked refrigerant pressures, checked delta t, checked blower wheels, flushed drains, cleaned flame sensors, checked IAQ, tested heat and cool at thermostat. Found low refrigerant pressures for upstairs system, added about 1lb r410a refrigerant per customer request to get to proper operating pressures. Found capacitor for main floor system showing age, quoted repairs. Systems working as they should at this time.

Completed homecare visit today on 2 gas systems in attic. Inspected ductwork, filter, flushed drain line and tested heating operation. Checked gas pressures and adjusted to manufacture specifications. Tested electrical components, took amp draws and verified system operation from thermostat. Inspected outdoor unit electrical, refrigerant levels and checked condenser coil overall condition. Installed EAC, 16x25x1, and replaced humidifier water panel on main level system. Washed condenser coils. Systems are fully operational at time of service. UV bulbs have been ordered and will return to install once arrived

The customer is selling his home and the inspector had notated that the GEC (Grounding Electrode Conductor) had been cut away from the ground rod. After further inspection the following was found and corrected: *The GEC was cut away from the rod *The Ground rod was sticking above grade *The GEC was not secure I made these corrections and established clean connections on all points that was bonded. Due to the age of the home I found only one ground rod near the service disconnect. This rod should be tested to ensure that 25 ohms or less is present per the National Electrical Code and if not another ground rod and bonding jumper should be installed to ensure the system is establishing good grounding.

Customer called us out for dishwasher not draining properly. Tested appliance and found no issues at this time, dishwasher is draining fine.

-Conducted electrical troubleshoot of master bedroom circuit and vent hood circuit. -Replaced defective GFCI outlet on back patio.

Today we came out due to system not heating. Upon arrival furnace was only running on fan mode. Power cycled the unit and called for heat. As soon as the inducer tried to come on it made a grinding noise. Inducer motor has failed and needs to be replaced. I also found several cracks/separated eye lits on heat exchanger. I informed customer I could not perform a carbon monoxide test due to repairs needing to get system up and running first. Flame sensor has heavy carbon build up on it. Blower wheel has dust and debris built up on fan blades. Capacitor is failing for blower motor. It’s rated 7.5 MFD +-5% and actual reading is 7.01. There is no float switch on drain line. System is 90% gas furnace, but fresh air intake is from the attic. It needs to be grabbing fresh air from outside of house. After going over all findings and options, customer has agreed for project manager to come out tomorrow quote replacing system. Project manager is scheduled for tomorrow between 2pm-5pm.

Full system installed for main floor with: New safety switches 2 new smart thermostat New media AprilAire cleaner New supply plenum New drain pan New outdoor pad

Installed customer supplied car charger.

Replaced two breakers that were damaged when storms rolled through a few days ago. 50 amp oven breaker and 70 amp ac breaker were replaced. New surge protector was added in the main panel.

Replace panel inside the garage

Replace all existing be our smart breakers